MF DIGITAL OptiEC Pro 6 Specifications download pdf (Page 10)

ProgRes

MAC CapturePro 2.7, Release 001

Safety instructions

2 Safety instructions

The ProgRes

digital microscope camera is manufactured and tested ac-

cording to the regulations speciﬁed in EN60950 / VDE0805, and was in

perfect working condition when leaving the manufacturer’s premises.

In order to maintain this standard and to avoid any risk when opera-

ting the system, please make sure to comply with the advice and the

warnings contained in this manual.

No warranty will be assumed by the manufacturer during the warran-

ty period if the equipment is operated without observing the safety

regulations. In any such case, JENOPTIK shall be exempt from statutory

liability for accidents resulting from any operation.

Please read this chapter carefully and observe the regulations in order

to ensure your safety, and to operate the ProgRes

camera as intended.

Please observe the warnings and notes printed in this manual and on

the unit.

2.1 General safety information

Expansions and alterations

The system must be operated in accordance with the instructions.

Any expansions, re-adjustments, alterations and repairs may only be

carried out by persons who have been authorized by JENOPTIK.

The electrical installations of the room where the system is set up must

be in accordance with IEC requirements. Please refer to chapter 2.4

“Electrical installations“ for the electrical installation conditions, and

observe the information contained in that chapter.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 89 90

No comments

MF DIGITAL OptiEC Pro 6 Specifications Page 10